How to Run Diagnostics on Your Kenmore Elite Washer: A Step-by-Step Guide

Learn how to run diagnostics on your Kenmore Elite washer with this easy step-by-step guide.

54 views

To run diagnostics on your Kenmore Elite washer, follow these steps: 1. Ensure the washer is in standby mode (plugged in with all indicators off). 2. Press any three buttons (except Power) in sequence: 1-2-3, 1-2-3, 1-2-3 within five seconds. 3. All indicators will light up, and the diagnostic mode is active. 4. Rotate the cycle selector knob to navigate through each function test. Consult the user manual for specific error codes and solutions.

FAQs & Answers

  1. What are the common error codes for Kenmore washers? Common error codes for Kenmore washers include F01, F02, and F20, which indicate issues with the control board, drainage, and water supply, respectively.
  2. How do I reset my Kenmore Elite washer? To reset your Kenmore Elite washer, unplug it for 5 minutes, then plug it back in and try running a cycle again.
  3. What should I do if the diagnostics don't show any errors? If the diagnostics don't show errors but the washer is still not functioning properly, refer to the user manual for additional troubleshooting steps.